Linocut Printing Top Tips

Feb 14 2022

Linocut Printing Top Tips

 

Linocut printing is such an accessible technique. It’s cheap and easy to get set up and can be quite addictive when you get going! The basic set up is: lino, tools for cutting, a roller, ink, paper and a wooden spoon or clean roller to print with. There are lots of different kinds of cutters and ink to choose from.

Top tips for lino printing are: work in black and white and block shapes rather than line drawings, as they can be confusing to work from. Keep it simple when you’re starting out!

Don’t forget to reverse your images - especially important when working with lettering!

Thin, strong paper works best when printing by hand. Japanese papers are lovely, but expensive. Printer paper is ideal for test prints and beginners.


Project - Print Your Initial!

Draw around your lino block to make sure your design will fit.

Linocut Printing Top Tips

Sketch out your initial in pencil, then work out your design in black ink. You can work back into the black ink with white pencil or acrylic paint. Don’t worry if your letter is a bit wobbly, the wobbles will either get worked out when you cut the block, or enhance the look of your print.

Linocut Printing Top Tips

When you are happy with your design, trace it, flip the tracing paper over so it’s pencil-side down, and transfer onto your lino block by rubbing over the lines.

Linocut Printing Top Tips

Start to carve the block, always cutting away from your fingers. Take your time, and don’t try to carve too deeply, you don’t need to gouge right down to the backing. You can check your progress by taking a quick pencil rubbing.

Once you’re happy with the block, squeeze a small, grape sized blob of ink onto a smooth surface, such as perspex. Dip your roller into your ink reservoir and roll out a square onto your inking surface to get a smooth, even layer of ink onto the roller. You usually need less ink than you think, and it is better to build up thin layers of ink, rather than losing definition in your print by using too much. Once the roller is evenly coated in ink, roll it onto your block, making sure all the raised parts of the block are covered in ink.

Linocut Printing Top Tips

Lay your paper on top of the block, being careful not to move it, gently pressing the paper down to help it stick to the ink. Use either the back of a wooden spoon or a clean roller to rub over the whole area to be printed, using firm pressure. You should start to see the image appearing.

Lift the paper off the block by peeling it back from the corner. Your print is ready!

Linocut Printing Top Tips

Back